Mugen headers doesn't fit b16a

[JDM DC2R]

Check the engine number. If fine you got the wrong header. And yes thats what she said!

[atari]

I purchased Mugen headers a couple years ago and had the same problem. I returned it back to the seller.. I did eventually buy one. If the holes/studs don't line up the headers are not for your engine. I still have my mugen b18/b16 headers in the garage. I can measure the holes for u if you want to compare? I've already had the header on my b16a2 so I know it fits

[spidertunez]

i have b16a1 and my freind have a b16a2.

Atari: Can you do that please?

[lil_foy]

Are you sure it's not a d series header?

[TOm.C]

Didn't know mugen made headers for d series, Can some one confirm?

[spidertunez]

It might fit into d series. . I just came back from burbs engineering
He told me the Holes is way too out.

My question is should the seller refund the money back to me

[atari]

I measured the hole distance from my headers
Hope the picture helps VVV

O 9cm O 8cm O 9cm O
O 8.5cm O 8cm O 8cm O 8.5cm O

Key:
O = holes
*cm = space in between holes

There is no d series mugen header I believe. You might have one that's for a prelude
I hope it works out for ya

[spidertunez]

thanks atari.. will buy you drink 1 day

[90LAN]

searching the no on the jasma plaque will tell you what it is some times

[VTURBO]

if they the gasket done fit maybe its for somthing else post a pic maybe from H22a or somthing only way to know is if u post pic and measure the stud holes and post it

[VT3C]

I had Mugen B18C 4-1 Header on my EG/B16A(2).. it's made for B18C-R/B16B but fits B16A also. gen1 and gen2 B16 are the same bolt pattern etc.

what is the number on the JASMA tag ? i cant quite read it..

$600 was a good price too !