im experiencing steering wheel vibration during braking on highspeed 100kph+...i think.my front rotors are warped...any shop you can
recommend for refacing my rotors...thanks
go to some industrial park at night and do some hard braking, should straighten them out
Hey, Do you guys know how i can get my Coilovers to go lower. I have HKS HiperMax Vsport and its tge lowest it can and im not quite saticfied with it. My friends told me to take out one of the adjusting collars but it is not reccommended. Would i be able to buy different springs from HKS and put them in or anything. The ride is a bit soft aswell (On max damper) so some stiffer springs would also be nice
No perches in the rear is fine. I went without them for ages. Low as hell though haha
How thick is the collar ? If its say 7mm thick and you remove it you will lower the car 14mm as the ratio is 2 to1. Thats cause the spring is halfway along the arm, for the front the ratio is 1to 1.
Here's a tip for keeping rotors unwarped.
When it's raining or wet on the roads, don't sit at a stop with your brake pedal down any heavier or longer than necessary. The hot pads on one side clamping down and the water cooling the rest of the rotor tends to accelerate warping.
Bookmarks