Installing aftermarket head unit on dc5

[Baby Face]

i believe these later integras began to use the same Headunit as found in other model hondas, so look up the accord from that era or the civic one and see if it looks the same and if there is a plug for that car.



anyway, since you dont have dash control or steering inputs just put some bullet syle crimps on them, then its easy to revert later.

[integraR]

http://www.ozhonda.com/forum/showthr...wiring-diagram

[crobaa]

Looks like a splice job is going to be done. Can anybody confirm the colours already match as stated in that thread ^

[Baby Face]

you can do it and confirm it for us.

if for any reason you are uncertain use a battery against the speaker cable one wire either end and listen for static.

a multimeter will help for the others.

[crobaa]

Yep, I'm actually an electrician, just ceebs working with wires all day at work then coming home and doing it again. But I will, and report back here tomorrow upon completion

[RenzokukenJ]

Yep, I'm actually an electrician, just ceebs working with wires all day at work then coming home and doing it again. But I will, and report back here tomorrow upon completion

Should be a 5 Min job for you m8

[crobaa]

Ok guys just got it installed but it won't turn on, I have constant 12v but no voltage on the switched ign wire. I have checked every fuse under dash and hood and they are all fine. Is there a trick to this?

[RenzokukenJ]

if you hook up the ign wire to the 12v constant does it get power?

if so then your ign wire must be weird, might have to get ign from somewhere else

[crobaa]

Fixed it, this diagram the ign and illumination wires are around the wrong way. Pretty happy with the install, just need a new facia trim ring as the alpine one was a bit thick

[RenzokukenJ]

nice m8

[Baby Face]

i found my alpine was too thick too, if forced on it would pop itself off.

a sony or pioneer one might do the trick i think.