DIY DC5 HID install

[ECU-MAN]

Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!



AIM: Install HID's in a DC5 Integra

Tools: 10mm 3/8 socket; 3/8 extention bar; 3/8 wratchet; phillips head screw driver; insulation tape

Steps:

Step 1

remove the front bumper bar, the yellew arrows piont to screws that need to be removed, the blue arrows point to clips that need to be removed. to remove these clips lift the center part then pop out the clip.
















STEP 2

remove head lamp assembly, remove 4 nuts, see yellow arrows below, disconect the lamps, see red arrows


















STEP 3

mount the HID transformer, undo the bolt from the gaurd, mount the transformer.








also run the wires for the HID globe up to the engine bay through the cut out.

STEP 5
Install the HID globe




STEP 6

plug in the transformer power feed from the head light low beam connector, make sure you wrap up the connector with insulation tape, also ensure corect polarity.





final result





do the same for the other side and install your heal lamps and bumper in the revers order you removed them.





I would like to thank Dundas and Jenza for their help with this install





Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!

[Trust-Me]

wow very nice write up ECU-MAN. very detailed....now i need to get some HIDs and follow ur steps hehe..

[[stealth]]

too easy.... HID BLING!

[_JENZA_]

woahhh sooo shexual... hahah

[wynode]

Nice work John!!!!

[fongyfong]

top stuff, ur ryde looks shexy jen

[JINRAI]

definitely a very beneficial thread...good work!

[blksin]

Good Stuff

im curoius wat kelvin are they ???

[egSi]

cool cool.

well done man

[luzinit]

can we get a pic of the HID's up against the wall? also do dc5's have a reflector like housing similar to the EK's or a projector like DC2's? i've been keen on getting a set for my EK however i dont want to blind every single oncoming car with light scattering all over the place!

[dundas]

i think they are 7500k
they are quite bright and none of the other drivers on the road seem to mind them too much as we have not encountered any high beam flashes yet (touch wood)
i must say that car is quite sexy.

[TeMp]

can we get a pic of the HID's up against the wall? also do dc5's have a reflector like housing similar to the EK's or a projector like DC2's? i've been keen on getting a set for my EK however i dont want to blind every single oncoming car with light scattering all over the place!

DC5 have reflector light units similar to EKs. BUT jdm dc5 have reflector light units which r designed for HID unlike our audm.

Those HID look like 8k to me (same as mine).

Once in a while I get high beamed but not biggie.

Nice write up mate!