Alex's B20VTEC DC2

**Super-DA9** · 25-11-2013 10:02 PM

Originally Posted by ivseenwars

I need an engine crane to get the motor out, which I dont have. Planned on removing the head and putting it on the b20 and once the motor is built then id just drop the b18 block out the bottom.

I thought about doing internals but its way more money than I wanna spend on the motor itself. Itd be 400ish for pistons and rods then another 300 for the rings etc, that money could be better spent on a 4.7d fd & LSD.

I dropped my engine out through the bottom without a crane initially.

if you have a jack that can lift fairly high and a bunch of sleepers you'll be right :P

Oh ok fair enough. Any idea what compression ratio you end up with using the B20 stock internals and c2 head? the c2 head should help to increase the compression.

**ivseenwars** · 25-11-2013 10:05 PM

Originally Posted by Super-DA9

I dropped my engine out through the bottom without a crane initially.

if you have a jack that can lift fairly high and a bunch of sleepers you'll be right :P

Oh ok fair enough. Any idea what compression ratio you end up with using the B20 stock internals and c2 head? the c2 head should help to increase the compression.

I have an SCA jack that doesnt even get under my car anymore

need to get an arcan haha

Not sure of the exact ratio but you gain a tiny bit of compression