Using the metal bands. If I was doing it wrong it should be a problem on the other 3 boots that I replaced, so thats why I'm posting here to get some other ideas. Maybe the machined groove is worn/out of spec? Dunno...
Using the metal bands. If I was doing it wrong it should be a problem on the other 3 boots that I replaced, so thats why I'm posting here to get some other ideas. Maybe the machined groove is worn/out of spec? Dunno...
did you use this to tighten the metal clamps?
S P A M | W O R K S
With our special rotational tires, it will allow you to drive very fast. - JK Tyre
OP did u make sure the groove is grease free when tightening?
A little trick to prevent weeping is smear some liquid gasket or similar around the band end and onto the cup itself. If there is a slight chance of a weep this will seal it up
Bookmarks