My Baby EG5 Civic

[3K9]

out of all that list-

no to hardrace camber arms, rubbish, shit hardware that comes with, shit overall finish, will rust where its not painted, ugly welds
no to plm header, i had to pay an exhaust place 2 hours labor to make mine fit (i installed it, took it to the exhaust shop to marry up with my exhaust, the piece of shit header was facing up into my floor )
if its your daily don't delete aircon, i strongly regret doing this to my car (summer up north sucks hard)
why two different tyres?

rest looks ok

ball joint- put weight on it (jack) the hit the arm with a hammer, or buy a ball joint separator for 30ish bucks

u mad. Have you gone mad? Hardrace is lovely quality!

Have you read the delete sound system and headunit part?
Have see my Jazz thread? Dat auto is my daily.
Might as well start racecar diet now.

Bought the set of my DC2R stockies with used Toyos. Two had excessive camber wear just down to the wire at one part.

Just go out and buy a balljoint remover. Repco or sca has it about $20-40. Will make that balljoint pop out very easily. As mentioned you could hammer the shit out of it like literally but you need alot of room space. Buy the ball joint popper.

Roger that.