Ok so I checked the codes and got the same 6 14 36 started to pull hair because i had already tested sensors and they were good then i decided to look into wiring and quickly found that there were a few plugs in the wrong places, IACV plug was in the radiator fan plug swapped it BAM code 14 gone. i then scoured the net to find what wired connectors are for which coolant plugs and BAM found the fan plug was in the temp sensor. Heres where it gets abit complex the original plug in the IACV was a Yellow w Black stripe and Red wire connector when i searched it up i get Vacuum sensor plug but i cant find anywhere to plug it in and im not getting any codes for it. I was also stumped because i couldnt find another plug on the loom for the temp sensor only thing i could think of was the previous owner in all his wisdom decided to cut it off, low and behold i found 2 wires for the sensor cut/taped and tucked into the loom sleeve...

So my question before i make a topic for anyone reading is it ok to cut the connector off the vacuum sensor plug and use that? or is there somewhere its spose to be plugged that im not seeing?