white line rear sway

[izzy]

alright dudes, just got my sway bar 18mm installed by ben la!
its bloody awesome, changes the dynamics of the car.

i recommend it to anyone without a sway bar la.

you can now take corners like a maniac. compared to whenu have no sway bar.

also vouch for ben's installation.

WOOT!!! awesome

[Paul1985]

Lets see this bar rip out of my subframe along with this reinforcement!:

[Zdster]

Holy cow, that looks like a heck of a lot of reinforcement .

[Domokun SPL]

Wow, the std subframe must mega suck...

With an upgrade like that, you should be able to put whatever anti-roll bar you want.

But remember, hard/stiffer isnt always better. Set up for balance, specially on the road.

[|N|]

Wow, the std subframe must mega suck...

With an upgrade like that, you should be able to put whatever anti-roll bar you want.

But remember, hard/stiffer isnt always better. Set up for balance, specially on the road.

after driving some white eg i cant agree more with this statement

[A.G.System]

JUst had to re fit all the bolts on my rear bar after one of the origional ones supplied (one of the few) cane off mid corner and pulled the centre of the nolathane bush with it.

$9 at Banner Hardware for all new Bolts, Nolathane Nuts and some nice fat washers.

That bitch aint going no where now.
Actually feels 100% better since re fitting and some of the strange creakes that it used to have have gone also.

[chameleon]

mine was making noise cos it was hitting the LCA.
had to get washers to give it more clearance.
my car (civic ek1 sedan) is not lowered at all.

anyone else have this problem?

[|N|]

mine was making noise cos it was hitting the LCA.
had to get washers to give it more clearance.
my car (civic ek1 sedan) is not lowered at all.

anyone else have this problem?

i have exactly the same problem .. and its still going it

[wynode]

Not trying to be a smartass but have you installed it the right way around?

[|N|]

Not trying to be a smartass but have you installed it the right way around?

YES BOSSSSSSSSSSSSSSSSSSSSSSSSSSSSs. at least ben did

[A.G.System]

mine was making noise cos it was hitting the LCA.
had to get washers to give it more clearance.
my car (civic ek1 sedan) is not lowered at all.

anyone else have this problem?

Was it yours that was posted in a pic a while ago?

If it was the brackets were back to front.
The bar should sit out not against the chassis.
Maybe take it off and try and re fit it again.

Also note that i didnt bother with the LCA 120mm bolt because i wasnt fitting the other brace.
Makes no difference with the way it handles. And less hassle due to not having to undo the LCA and putting it back in.

If it wasn't then just ignore this reply