Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
Aim: Gauge cluster replacement.
Required: 1 x phillipshead screwdriver
Steps:
The JDM DC5R Cluster:
Remove the dashboard lower cover. should have knobs on the both side that you twist to remove them:
Removed:
Then remove the upper column cover by removing the 3 screws off lower column cover:
Scoot your seat all the way back. You have to get your head all the way inside/under the dash. If you look up under the dash you will find 2 screws at the top (philips) remove both of them. Image shows one of the screws located on the right side of the cluster:
Once the screws are removed, reach out the the back of the cluster and push the cluster out. Or pull it out from uptop. Then disconnect the connectors and remove the gauge.
Install the gauge cluster in reverse order of removal. You are done! JDM.
Bookmarks