Scrapping

[[[d a n n y]]]

Yo.
i got abit of scrape when i go over bump and turn corners hard.
how can i fix this

in my knowledge the car shouldnt scrape

cars been lowered 2" with 195/55 tyres all around.

the rear right scrapes.

[STTICH]

get 195/50 tyres?

or roll the guards for a start.

[[[d a n n y]]]

dont wanna roll the guards

last time i rolled my guards my Guards got ****ed up badly...

so i dont wanna do it..

so u recon lower profile will help me more?

[egSi]

danny i got 195/50s and u know how low i am. i dont rub/scrape anwhere

[bennjamin]

offset of rims for a start danny boy ~ and coz ur springs are very soft , they will pivot to either side easier , which might be the reason for the premature scraping.

[pocketrocket]

My rims are 15x7 4x100 with an offset of +40. I have 195/50 rubber and its kinda low, but not low enough and it doesnt scrap at all, even while turning. It only scraps when going over speedhumps which is unavoidable and going down steep driveways.

[Domokun SPL]

Stiffen up the suspension

Raise the car

Drive diagonally

Drive slower, let suspension uncompress

Avoid those areas

Get a higher body kit/smaller exhaust if thats what hits

[[[d a n n y]]]

Stiffen up the suspension

Raise the car

Drive diagonally

Drive slower, let suspension uncompress

Avoid those areas

Get a higher body kit/smaller exhaust if thats what hits

i dont get it

it's only the rear right scrapping..
the whole car goes over speed bumps with ease

[Domokun SPL]

Hold on. Maybe you need to define scraping.

To me, that means that the car is too low and part of a car is hitting the ground, aka scraping, along when turning/over bumps.

BUT, what you seem to describe is rubbing, which is the tyre rubbing the gaurd.

If you are refering to the 2nd than the first, there is definatly something wrong with only that one side. Either offsets/width combo is no good, the shock is old and allowing too much compression or many other things.

Please just clear up for me, rubbing or scraping?