eh.. quite common in aftermarket stuff like this.
you can do it yourself.
there is a DIY how to rip apart a standard EK headlight, follow the same thing to do your angel eyes.
clean em, then re-seal em.
basic step.
1. take out headlight.
2. take out bulbs, and fittings, rubbers, seals etc.
3. pre heat oven to 150 degress.
4. put in the head light for a few mins should soften the glue.
5. wearing gloves, take off the lense, you can use a screwdriver, as leverage, it should just come off.
6. clean inside of you headlight.
7. get a good silicone, and run it along the case of the headlight, and put the lense back on, apply pressure, to properly seal any gaps.
Bookmarks