OEM Fuel Filter info?

**egSi** · 09-07-2006 05:39 PM

does anyone know the pressure the OEM fuel filter can withstand? or what it runs at? also does anyone know how fine the filters are in these?

thanks in advance.

**bennjamin** · 09-07-2006 05:55 PM

not really helping ~ but for aftermarket fuel systems and engine setups ive seen OEM fuel filters cope fine. (extra flow and pressure)

**90xsi** · 09-07-2006 06:34 PM

Just call Honda parts or a aftermarket company and ask to speak to tech/engineering dept,

eg ryco www.rycofilters.com.au/

last time i had to call them about a certain fuel injected filter, and it was around
120psi for a basic one.

**egSi** · 10-07-2006 07:42 AM

thanks guys.

im not really lookin to see if itll cope but more of what specs it has so i can replace it with an aftermarket equivilent.

**bennjamin** · 10-07-2006 07:48 AM

refer to this thread Sir Travis ~

Honda-Tech.com: WRITE UP: How to convert your fuel lines and ugly filter to Stainless -6AN hoses

something im doing myself

**Slow96GSR** · 10-07-2006 08:02 AM

Converting is easy. Edelbrock makes conversion parts so it's even easier. The stock filter is fine to run on high PSI and higher volume but I don't know exact numbers. The filters shown in Bens link will out perform the stock filter but do cost more, and if it isn't a cleanable filter and gets dirty faster then the stock filter it might not be worth it. A stock filter is only like $15USD.

My $.02USD!! I'll look for some numbers tomorrow when I get to the shop.