100w/90w bulbs in EK

[destrukshn]

lol, i'd suggest, not yet.. until they blow, just in case, you screw the bulb, becuase the pins from the bulb can actually dislogde from the bulb it self when you attempt to take em out, everytime i'd done em to bulbs like this when taking em out, it's happened.
and the plug looks wonky.
lol

[wynode]

Thicker wiring to allow more current through gives a higher dissapation of heat in the wire.

Thicker wire is used to carry more current. Thinner wire will dissipate more heat than a thicker wire carrying the same current.

[TYPE-ONE]

i was using a wiring kit in my eg with 100w mtec globes. The globes lasted quite long and were damn bright. It can work and if you use Fuse Holders Between the harnesses you can prevent blowing shit up.

But this setup cant compare to HID of course.

[chilli]

lol, i'd suggest, not yet.. until they blow, just in case, you screw the bulb, becuase the pins from the bulb can actually dislogde from the bulb it self when you attempt to take em out, everytime i'd done em to bulbs like this when taking em out, it's happened.
and the plug looks wonky.
lol

lol thanks for the advice. In that case ill just leave them be and worry about it when they blow =P .. their only 3 months old.. so i hope they last forever!!!