converting from carbs to injection

[simonk]

just ditch the ol carby engine and ring around for a decent D series engine from a wrecker ..

if i saw this thread b4 i ditched my old D16Z2 Efi engine to the dumps, i would of just given it to you "literally"

as the wreckers didnt want anything for it ... hahaha

good luck champ!

oh poo!! never mind.....

I'm buying bennjamin's D16A8, all I need is the loom that goes from the firewall to the ECU

what are the specs of the D16Z2 ?

thanks for the details RMN15N - helps a lot, all these codes screw me right up

[iamhappy46]

You need more of the loom than that. EFI fuel pump wiring, Fuses/Main Relay and some major rewiring of the plug near the brake master cylinder need to be done.

[simonk]

You need more of the loom than that. EFI fuel pump wiring, Fuses/Main Relay and some major rewiring of the plug near the brake master cylinder need to be done.

don't worry matey- it's not even going in a honda, there's a whole lot more needs to be done than just some extra wiring...

as long as I've got what I need to make the motor run, it'll be OK

[RMN15N]

oh poo!! never mind.....

I'm buying bennjamin's D16A8, all I need is the loom that goes from the firewall to the ECU

what are the specs of the D16Z2 ?

thanks for the details RMN15N - helps a lot, all these codes screw me right up

no problamo!. anytime aye..

[XB-16-AX]

what are the specs of the D16Z2 ?

they are an JDM D16Z2 1.6L SOHC PGM-FI

i think they are rated around 86.5 to 88.7kw @ flywheel stock.

my old engine went hard with just pod, extractors .. had done up SSS and GLi civics for breakfast..

props to the good ol' D16Z2

[iamhappy46]

For some reason, when I read your original post... I thought you were doing up a Civic Wagon... LOL