Results 1 to 4 of 4

Threaded View

  1. 16-05-2009 11:24 AM #1
    qikteg
    qikteg is offline
    Member Array
    Join Date
    Apr 2006
    Location
    Sydney
    Car:
    DA3 Integra

    Ignition timing adjusting connector

    first of all, what is it?

    I'm wiring in a PR3 ECU, obd0, and the previous wiring setup (d16a3) didn't have one (most likely because it ran on vaccuum advance ignition).

    will i need to get one, and if so, where are they usually located?

    *Edit* also, where can i source the "electrical speed sensor", when again, i didn't have one with the original loom?
    Last edited by qikteg; 16-05-2009 at 12:41 PM.
    You never go ass to mouth!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules
Powered by vBadvanced CMPS v4.1.3


Terms and Conditions
Ozhonda.com is in no way affiliated with the Honda motor company or Honda Australia in anyway whatsoever.