DIY: Get that lip sitting straight.

[beeza]

Ok,this is simple as,but some things are and until you see someone else do it,you ignore it,it slowly gives ya the shit's.Then you see this and go,offcoarse,easy,why didn't I think of that...hehehe

So,it's just long bolt up through the bottom of the lip and through the bumper.Held on with a lock nut and washer's to stop the head of the screw and/or nut pulling thrugh the plastic





Mmmm Straight



Offcoarse,the same for the front.If,for some reason it sags in the middle,just stick one there

[Int3gra-T]

doesnt look straight....
.
.
.
.
.
.
jk.

[beeza]

hehehe,it's decieving huh

[beeza]

bumps

[dudeling7]

haha nice, i did this with my front lip to get it just right - i hate lips that dont fit nice and straight but angle up and in all directions lol

[vinnY]

with the muffler that close, does it melt the lip at all?

[beeza]

It dosen't Vinny,there's a good 1cm gap there and it's sweet.

[xntrik]

nice diy

[beeza]

Thank U!

[SiReal]

thats a really simple, 'think outside the square' DIY. i will do this to my mates rear lip, which has exactly the same issue.

[beeza]

Thanks Jeff!!

[AKmotorworks]

nice thinking brettles, now get on to the track, that lip is going to give u 5kgs of aero downforce :P