Quote Originally Posted by bennjamin View Post
I should be exact -

For the ASR kit -
EK4 and EM1's require the mounting holes to be drilled out. This is to allow the bolts to grip firmly and properly to the reinforcement behind.
I believe you CAN leave it , but it made strip the thread of the bolts as you tighten the bolts through it.
For the BEAKS kit , you need to drill an extra hole thru the bottom of the subrame for the lower bolt to go thru. (below the 2 mouning holes either side)I believe this is the case for all EK's.

Anyway a BEAKS or ASR kit + ITR or CTR swaybar is a good combo
no drilling on ek and em1 required..

u cant exactly drill the holes for the EK as from memeory the ek aSR block lower bolt is threaded