Hey, im 15, a noob and this is my first DIY so be kind to me

Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!

Aim: To get rid of the stock mirrors and install electric spoon style mirrors.

Required:
  • Pair of Electric Spoon style mirrors
  • Electrical tape
  • Phillips screwdriver
  • Flat-head screwdriver
  • 8mm spanner/socket


DRIVERS SIDE

Step 1:
Remove the screw behind the door latch



Step 2:
Remove the screw inside the door handle



Step 3:
Unclip the connection from the power window controls



Step 4:
Remove the black plastic screw from the inner of the door panel



Step 5:
Get a flat-head screw driver and slide it under the door panel and pull it towards you to unclip the door panel. Repeat in all different areas until all are unclipped



Step 6:
Once then lift the door panel out by sliding it towards the right



Step 7:
Then use the flat-head screwdriver again to unclip the black triangular panel thing



Step 8:
Grab the 4 wires (blue, white, black and red) that came with the spoon style mirrors and cut the ends (the red wire doesn't need to be used)



Step 9:
Then splice the 3 original wires (yellow with white stripe, yellow with red stripe, yellow with black stripe) as so



Step 10:
Connect the black wire to the yellow with white stripe wire

Step 11:
Connect the blue wire to the yellow with red stripe wire

Step 12:
Connect the white wire to the yellow with black stripe wire



Step 13:
Then take the 8mm socket and unscrew the 3 bolts that are holding the original mirror, like so



Step 14:
Then push the white clips, the top and bottom till the mirror comes off



Step 15:
Then take the rubber off the original mirror and place it onto the spoon style mirror





Step 16:
Now put the spoon style mirror on, and take 3 screws to hold it together




Step 17:
Now cover all the connections that you have made with electrical tape, and also i used some plastic that you use for your subwoofer to cover all of it together (optional)





Step 18:
Now connect the connection and replace the triangular plastic panel




Step 19:
Now replace the door panel by repeating steps 1-5 in reverse

PASSENGER SIDE

Step 20:
Now do the exact same till it comes to the wiring

Step 21:
Connect the white wire to the yellow with white stripe wire

Step 22:
Connect the blue wire to the blue with black stripe wire

Step 23:
Connect the black wire to the blue with white stripe

Step 24:
Admire your work



If you have any questions, just ask me.

Thanks Nick