Just stick it to your bumper using double sided tape.
I think you can also buy them with sticky stuff on it already
SPAMMAPS
Carburettor|Nation
that mikey G guy is the biggest shit talker ive ever met..
in the space of 15minutes he sold two sets of wheels. claims a guy under the username DNT-CRY bought them!
Buy them off ebay for $50 and install them yourself, its not hard to do.
Remove the rear bumper
Measure and Drill the holes with the supplied 20mm drill bit
pop the sensors in
route the wires into the boot through the existing accessory hole
mount the reverse sensor unit behind the carpet somewhere (above the wheel arch for example)
Connect/tap the power wire to the Reverse Light wire
Connect Earth to the Chassis
Route the Beeper/Screen into the cabin via the C-pillars (side of the rear seats)
Mount the Beeper/Screen under the seat or dash or where-ever you want.
If you cant install it yourself, get an auto electrician to do it, it takes less than two hours (probably 1 hour for a prr), so labour wouldnt cost too much. Maybe ~$150
hey mate not sure why you want that look, but anyway, my dc2r has factory honda reverse sensors.... I think these are the same as the euro and a few other models.....
Yes thats the studs i want, was the rubber thing ment to be a joke? its so ugly!
No it was not a joke. Not when this was in your first post:
Originally Posted by viper8548
Does anyone know or heard of fake stick on studs that you can just stick onto the bumper to achieve the luxurious look? Hopefully it will be dirt cheap and would be a nice cosmetic mod.
Originally Posted by aaronng
Bookmarks