| 
		
		
	 
	
	
		
			
	
		
			
				
					21-05-2008 02:28 PM
				
			
			
				
					#1237
				
				
				
			
		
	 
		
		
			
				
				
						
							
							
						
						
				
					
						
							
	I have been searching for weeks for exhaust options for my FD2, so far come up trumps. I did find one by J Racing on ebay but it looks like a racing exhaust. I started a thread in the forum regarding cat-back exhaust options for my fd2 but nobody knows. I think we have to wait a bit for FD1's and FD2's
		
			
			
				
					  Originally Posted by markCivicVti   Well... I've just spent all evening "researching" exhaust options... So hopefully I'll get some replies and finally do my first mod soon    
For those of you who stated you had a cat-back exhaust system installed, what do you have? Something custom? As I can't find a single FD1 specific cat-back system.
 
Any help? 
				
                                       
                                 
				
		        		Michael---------------------------------------------------
 Fire Up Fire Up, 27 27, Fire Up Fire Up, Here We Go Here We Go, On the Road On the Road, 27 27, Fire Up Fire Up!!!
 
	
		
			
				
					21-05-2008 03:38 PM
				
			
			
				
					#1238
				
				
				
			
		
	 
		
		
			
				
				
						
						
				
					
						
							
	Use as a guide only. Perform mod at your own risk.
		
			
			
				
					  Originally Posted by howy   could anyone write up a simple DIY for the boot release please?   
 You will need the module (which interprets second door lock release signal to release boot lock and an actuator)
 
 1) remove floor trim on front passenger side. from inside wire loom, locate yellow door lock release trigger wire. (note: not to be mistaken for side airbag sensor wire which is also yellow)
 2) add a splice to this wire and run a 22g wire from there along the floor into the trunk.
 3) The module has 3 wires. (line to earth, line to actuator and line to yellow wire). Once you join up the 3 wire, attach the module to the boot lid with 3M double sided tape.
 4) the actuator has 2 lines,(line to module and line to earth. Attach the actuator to the boot (refer to picture elsewhere in this thread). ensure enough slack when boot lid latch is in locked position.
 
 there you're done
 
 
   
				
				
				
					
						Last edited by gerard; 21-05-2008 at 03:52 PM.
					
					
				 
	
		
			
				
					21-05-2008 08:26 PM
				
			
			
				
					#1239
				
				
				
			
		
	 
	
		
			
				
					21-05-2008 10:26 PM
				
			
			
				
					#1240
				
				
				
			
		
	 
	
		
			
				
					21-05-2008 11:50 PM
				
			
			
				
					#1241
				
				
				
			
		
	 
		
		
			
				
				
						
						
				
					
						
							wow..
 that's really bright
 
	
		
			
				
					21-05-2008 11:53 PM
				
			
			
				
					#1242
				
				
				
			
		
	 
		
		
			
				
				
						
						
				
					
						
							nice set up for both gerard and applio.
 Gerard: Agree with with mini euro, looks complex.
 
 Applio:  I wouldnt mind making my boot brighter.  At the moment, i have a strip of LEDs in the boot installed near the rear for better lighting.  Interior, i like mine dim.  Gives a nice mood feel
   
	
		
			
				
					22-05-2008 12:06 AM
				
			
			
				
					#1243
				
				
				
			
		
	 
		
		
			
				
				
						
						
				
					
						
							
	yeh I actually turn my centre interior lights off coz i find i don't actually need it for anything.
		
			
			
				
					  Originally Posted by Shimian   nice set up for both gerard and applio. 
Gerard: Agree with with mini euro, looks complex.
 
Applio:  I wouldnt mind making my boot brighter.  At the moment, i have a strip of LEDs in the boot installed near the rear for better lighting.  Interior, i like mine dim.  Gives a nice mood feel   
 i've recently installed philips blue visions into my fd1, they seem to be sufficient. Not as good as the HID's i had before but atleast they're ADR approved and legal
  
 my parkers are also blue visions but they're more yellow than white, anyone know which bulbs are best for a whiter colour?
 
	
		
			
				
					22-05-2008 12:20 AM
				
			
			
				
					#1244
				
				
				
			
		
	 
		
		
			
				
				
						
						
				
					
						
							
	
		
			
			
				
					  Originally Posted by Shimian   nice set up for both gerard and applio. 
Gerard: Agree with with mini euro, looks complex.
 
Applio:  I wouldnt mind making my boot brighter.  At the moment, i have a strip of LEDs in the boot installed near the rear for better lighting.  Interior, i like mine dim.  Gives a nice mood feel   lol my boot is also too dim... but the boot light flickers when the sub is on!
 
	
		
			
				
					22-05-2008 08:46 AM
				
			
			
				
					#1245
				
				
				
			
		
	 
		
		
			
				
				
						
						
				
					
						
							
	
		
			
			
				
					  Originally Posted by howy   yeh I actually turn my centre interior lights off coz i find i don't actually need it for anything. 
i've recently installed philips blue visions into my fd1, they seem to be sufficient. Not as good as the HID's i had before but atleast they're ADR approved and legal    
my parkers are also blue visions but they're more yellow than white, anyone know which bulbs are best for a whiter colour? Use MTEC parkers.  They are white and bright.
 
	
		
			
				
					22-05-2008 12:20 PM
				
			
			
				
					#1246
				
				
				
			
		
	 
		
		
			
				
				
						
						
				
					
						
							Applio --> how many watts are PCB SMD? are they LCD or what? super bright HID?
						 
	
		
			
				
					22-05-2008 12:27 PM
				
			
			
				
					#1247
				
				
				
			
		
	 
		
		
			
				
				
						
						
				
					
						
							
	^^^ yep, very nice white these MTEC, got them for my FD1 and i don't even need to turn on the HID when backing out of the driveway at 5 am
		
			
			
				
					  Originally Posted by Shimian   Use MTEC parkers.  They are white and bright.  . Get them from one of the trader here. 
	
		
			
				
					22-05-2008 05:10 PM
				
			
			
				
					#1248
				
				
				
			
		
	 
		
		
			
				
				
				
					My Mods
				
					
						
							2006 Honda Civic Sport
 
 K&N replacement Air FilterHID SystemType R Red BadgingExhaust SystemBlack TintsReplacement of all interior and exterior Lights to LEDReplacement of Hi Beam and Fog Lights to white xenon bulbs18" Lenso RS5 Rims (5 Spoke)Replaced back speakers to 4 waysType R Brake Pedals
 
 On the to do List:
 
 Have 4 ways for the front - got to find the time to put them inProjector headlightsLED TaillightsCAI KitLowering (ssupension)Brembo brake kit upgradeDVD system
 
				
				
				
					
						Last edited by tonz; 22-05-2008 at 05:19 PM.
					
					
				 
 
	
	
 
	
	
	
	
	
	
	Tags for this Thread
		
		
		
		
			
				 Posting Permissions
				
	
		You may not post new threadsYou may not post repliesYou may not post attachmentsYou may not edit your posts  Forum Rules | 
Bookmarks