JDM Dc2r can't find the right drive shaft.

[EG CIVIC]

Am thinking more in the line of like markoJEK1 - using the outer joint part of the k series axle (36mm) and putting that onto b series axles??

or just go with ITR 98 spec shafts if you can find them.

[Sir_vtec]

dc5r drive shafts 36mm but will not fit a b series engine at all!

[EG CIVIC]

don't know what modding was done to the axles but there was a member on here with a EG that used 98 spec brakes and still had d16y engine in it.

[vinnY]

have a read here

[fatboyz39]

dc5r drive shafts 36mm but will not fit a b series engine at all!

Sure? well a K series shaft can fit B series outers, so i dont see why it cant be done

[vinnY]

i think sir means the entire shaft not just the ends

in any case read the link i posted, says you can knock off a 36mm outer from an accord/prelude/crv and whack it on your current shaft

[Sir_vtec]

Sure? well a K series shaft can fit B series outers, so i dont see why it cant be done

u mean the k series passenger side shaft will connect with the mid shaft no problems?

[innozent]

not just a stock k shaft, use k outer to fit 36mm hub and b inner to fit the mid shaft.
cut the boot and zip it back to combine.

[EGBenny]

I don't know how they are doing it with k series. It would be pointless for honda to have a bigger drive axle if the spline of the shaft was the same as a 32 where it meets the outer cv joint.

have a read here

This guy says all hondas have same size splines of the shaft outer which is bs, I tried crv ones he says that i should have used accord or prelude outers (thats where i fked up)

Anyways i got the colour codes from some jdm itr axles and ordered a pair with new cv's from a1 axles . Should get them tomorrow.
(left side two purple stripes and right side one red stripe)

[mocchi]

congrats ben, what was the colour code mean?

[90LAN]

I don't know how they are doing it with k series. It would be pointless for honda to have a bigger drive axle if the spline of the shaft was the same as a 32 where it meets the outer cv joint.



This guy says all hondas have same size splines of the shaft outer which is bs, I tried crv ones he says that i should have used accord or prelude outers (thats where i fked up)

Anyways i got the colour codes from some jdm itr axles and ordered a pair with new cv's from a1 axles . Should get them tomorrow.
(left side two purple stripes and right side one red stripe)

nice to see u made use of my pics hope it work out for ya

[EG CIVIC]

I don't know how they are doing it with k series. It would be pointless for honda to have a bigger drive axle if the spline of the shaft was the same as a 32 where it meets the outer cv joint.



This guy says all hondas have same size splines of the shaft outer which is bs, I tried crv ones he says that i should have used accord or prelude outers (thats where i fked up)

Anyways i got the colour codes from some jdm itr axles and ordered a pair with new cv's from a1 axles . Should get them tomorrow.
(left side two purple stripes and right side one red stripe)

Nice! How much you getting them for?