turbo manifold???

[FastFwd]

do u run a/c fast fwd?

No a/c, i could probably fit it now with my new manifold setup but with the xspower one and the one after it both didnt fit the AC so i removed it. Plus it must of been about 40/50kg less and less pully of the crank so i removed everything for good. Piping everything.

[A-man]

aw serious
thats not bad effort

what radiator r u running? with that xspower manifold? im running twin core civic rad but in summer (today with a 12 inch and 8 inch thermo it over heats a little)

what temps do u get?

[FastFwd]

nah not running the xspower mani anymore...chucked that.

im using an aftermarket Aluminium Radiator. Forgot the name brand but its about 3 times as thick as the stock one. Runs alot cooler. always under 82 degree's where the stock was like 87-89 and would creap up when i thrashed the car a bit

[A-man]

lol yeh true mine does the same unless u have the heater on the whole time coz then it dont move no matter what u run

mine runs around 97 degrees on aftermarket gauge on the bottom hose... the stock engine gauge reads normal temp... ive just bought the pwr one hopefully this will fix it

[FastFwd]

I check mine from my Power FC A-man, straight from the ECU was around 35 degree's outside today in perth and it was running 79 i was like woahh awesome

[A-man]

aw k... thats good man

ive got a radiator shop looking into making mine a bigger capacity.. im thinkin about a 2nd radiator that is part of the 1st rad its just because space is a problem....

[myztery]

talk about off topic...
now back to the topic, has any one tried ak motorworks ram mani???

[Riced_Civic]

if the manifold i bought b4 hand doesn't work out i will be using one of theres as they are doing my kit.

[myztery]

if the manifold i bought b4 hand doesn't work out i will be using one of theres as they are doing my kit.

keep me informed on there mani please feed back would be appreciated...

[iced]

im going to use the same wastegate, i was refer by adrian at toda of the exhaust place. forgot the name though...steam pipe is a bit smaller which might get rid of a bit of lag

he prob referred you to haks at performance exhaust.
he does good work.

[dc4t]

if ur gonna go down that path of buying ebay manifolds, never buy stainless steel ones.. go for cast iron

[Limbo]

yeah he's good he's making mine also.

he prob referred you to haks at performance exhaust.
he does good work.