B18C back to stock

[fromdeeeast]

Hey, I have a DC2 Integra with a full turbo kit (not sure what type) and I wanna take off the turbo kit and return the car back to a stock b18c for my younger brother to drive.

I didn't install the kit myself i bought it done.

Now im not sure to what extent the turbo setup has been done but doesnt seem that extensive.

So would I have to replace the:
- Exhaust manifold
- Exhaust
- Intake
- Injectors
- ECU
- Head Gasket
- Tune

not sure what else.

But yer what else would i need done?

Also with the oil lines for the turbo, where would they go into the stock engine? I heard to the stock oil pressure sensor near the oil filter?

Thanks any help is appreciated

[fromdeeeast]

Anyone?

[IEVAQ8]

unless u post pics of lines and the likes its very hard on a custom setup for people to know where things should go or where they came from........

[yourfather]

unless u post pics of lines and the likes its very hard on a custom setup for people to know where things should go or where they came from........

yeap it really depends on what work has been done

[Limo]

- Exhaust manifold
- Exhaust
- Intake
- Injectors - stock if your not going to retune
- ECU - either another stock or retune

also
-disconnect extra vac lines to BOV, wastegate, gauages etc
-reconnect any sensors etc
- plug up the sump return or get another sump

not sure about the other lines

[bennjamin]

has the engine itself been opened up or modified etc ?
If the parts are truly BOLT ON (on the outside) then you can easily replace all aftermarket parts with OEM parts.

[Lukezen27]

has the engine itself been opened up or modified etc ?
If the parts are truly BOLT ON (on the outside) then you can easily replace all aftermarket parts with OEM parts.

That's a very good question!

If the motor was build for boost its more than likely got lower compression pistons..

Once un-turboed the car well drive like crap and be gutless as hell

[fromdeeeast]

How do I tell if the engine has been opened up and all?

[trism]

you cant unless you ask whoever built it

[onlykillzz]

can you afford to buy another motor??? if so why dont you just buy another b18c and swap the hole thing over and then sell the boosted one at least this way you might make some money on it and even if you cant sell the motor later you can just put it back in....

[Lukezen27]

How do I tell if the engine has been opened up and all?

What power and psi is she at?

[fromdeeeast]

not sure there bud?

she isnt very strong so im guessin its just a small set up.

So all i need is:
- extractors
- intake
- tune
- oil lines

and i should be right?

Cheers