Thanks for the DIY. I found the heater control panel tough.
Just wanted to add some tips and ideas I got by following ICYOIL -hope you don't mind me referring to your pics:
You can unplug the ashtray light (green) and slot it underneath the ashtray to expose it - use it as a map light or feet light or shove in a UV led and drive with a white shirt at night.
cross-sectional pic of screw location
note the pic is LHD so the air mix cable (temp change wire) is on the other side - just look under your glovebox for the blue cable as ICYOIL stated.
The back of my plug was connected to the foot vents by a clip - I broke mine trying to rip it off. So after unplugging, you should slide the plug to the left to release it from the clip.
To dismantle the metal arms from the face of the heater console:
1) push the two sides in to release that arm. 2) theres a plastic plug (not pictured) that sits ontop of the end of this arm, turn it anti-clockwise and pull it off to release the arm.
My gauge lights before I changed it all to blue.
Reply With Quote
Bookmarks