^ but that will cost you.
75.00 per scan at most mech's, just to SEE what the issue is, without doing anything about it. I guess the scanning machine costs a lot of money, so they pass that on to you.
do THIS:
http://www.k-series.com/tech_document.php?id=37
It takes the better part of 10 seconds, will tell you what is wrong, and is free (except for the paper clip)
Follow the photo, including which way the port sits, and you're set.
Too easy.
Usually after transmission work, it is an Air Fuel Ratio (A/F) Sensor at fault.
Reply With Quote
Bookmarks