EP3 Type R

[PeppeX]

My WTB thread for an EP3 intake hasn't had many hits so i thought i might post here to try my luck.

Please PM me or reply to my WTB thread if u have one for sale http://www.ozhonda.com/forum/showthr...vic-EP3-Type-R

[Mugen_B16B]

tbh, u should just get urself one from ebay since the dollar isnt to bad now

[Twest]

Which DC5R?

AUDM: 16 x 6.5 (45 offset) will sit in a little further than the EP3's

JDM: 17 x 7 (55 or 60 offset) will sit heaps in and will look really weird. Will need to run spacers to look right.

JDM dc5r rims are 60 offset, there was a pair for sale here locally. Tried them on..LOL. Needs spacers badly.

[NightRyder]

I have fd2r rims that are 60 offset. Only needed 3mm spacers for the rear, front didn't require any and looked fine to me.

JDM dc5r rims are 60 offset, there was a pair for sale here locally. Tried them on..LOL. Needs spacers badly.

[k0e1]

Hey guys just wondering if anyone could recommend to me a good place to get my EP3 serviced to see if there are any problems. It would be great if the place could actually get the parts for me too cause the one that i went to just tells me the problems and goes we wouldnt be able to find parts since it is an import. Thanks

[Perry]

Top one?

[Lukezen27]

My WTB thread for an EP3 intake hasn't had many hits so i thought i might post here to try my luck.

Please PM me or reply to my WTB thread if u have one for sale http://www.ozhonda.com/forum/showthr...vic-EP3-Type-R

I just installed a Injen on Sunday

Man you can actual feel the extra power gain and VTec Crossover is killer loud

[Philip Lee]

I just installed a Injen on Sunday

Man you can actual feel the extra power gain and VTec Crossover is killer loud

do u have cat back etc?

i recall when i fitted Fujita, i lost a little bottom end. once i got catback, i felt gain throughout the rev range.

[Lukezen27]

do u have cat back etc?

i recall when i fitted Fujita, i lost a little bottom end. once i got catback, i felt gain throughout the rev range.

Nope still stock back end

[nny911]

looking at coilovers for the ep considering buddy club n+ and Tein Monoflex
bit sceptical about the Buddyclub being made in taiwan but is the mono worth every cent?

[spookz]

looking at coilovers for the ep considering buddy club n+ and Tein Monoflex
bit sceptical about the Buddyclub being made in taiwan but is the mono worth every cent?

I just picked up a set of Buddy Club N+ from JDMyard during the meet. I'm yet to install it though, so far they look good - but that probably means nothing. LOL

[JohnO]

do u have cat back etc?

i recall when i fitted Fujita, i lost a little bottom end. once i got catback, i felt gain throughout the rev range.

same i fitted the rm01a and felt some bottom end! pace picked up after putting the catback on