LOL
My P72 plugs are 26 / 16 / 22 which is OBD-1 early model JDM B18C
My EG5 is obviously OBD-1

Im not even talking about my ecu anyways,
As i was asking about the plug located under the DRIVER SIDE the two pin SCS connector to read fault codes, thats what this thread was posted about.

This DIY covers the codes found on AUDM cars, although it can be adopted to JDM and USDM. These codes are the same for OBDO, OBDI, OBDIIa and OBDIIb. To retrieve codes from an OBDO vehicle you simply have to turn on the ignition switch to position II and look at the window on the PGMFI ECU and count the codes out from the flashing red LED, however on OBDI and OBDII cars, you are require to bridge what’s called "SCS" service check connector then turn the ignition on to position II, the yellow engine lamp on the dash known as "MIL" Malfunction Indicator Lamp will blink the codes.
So...
Does anyone know the colours of the wires to the "SCS Plug" in an EG5?