*** Official - What Did You Do To Your EG Civic Today? ***

[89lude]

shaved bay more and painted it

[sebtoombs]

Got all 4 in, rear left and rear right are same height but for some reason front left is 1cm lower than front right with the same thread length.

I have the exact same issue. I imagine it comes down to small differences in parts/tolerancing between the two sides. Just measure hub to guard and you'll be fine. My mate was having the same problem with his gtr too.

In other news, I adjusted the valve clearances on my poor old d15 (340000ks) runs a load better. Recommend this to anyone who hasn't had it done in the last 50-100000 ks

[charliebrown]

Got a good DIY for valve clearances?

[charliebrown]

Took it for petrol, scrubbing hard on all 4 corners. Only time it's not making sounds is driving straight on a perfectly smooth road.
Was gonna get the rears rolled and raise the front half an inch. Will this solve my problems ya think?





Sitting still, the tyre is about 5mm from the guard. Thought coilovers would be stiff enough so that they wouldn't have much travel

[Bludger]

Got a good DIY for valve clearances?

I can do it for you, along with the keyless entry, hurry up though, I'm not here forever

[charliebrown]

When ya free bro?

[Bludger]

it varies, call me to book in a cavity search.

[89lude]

i think if you roll the front and rear you shouldnt have any scrubbing issues at that height.

[charliebrown]

I had a look and it seems the front it's scrubbing on the fender lining not the actual guard. Might try and sand it down or cut it a bit, don't really wanna take it all out.

The point of it is to stop dirt/water splashing into your engine bay and to protect the wiring/loom shit?

[89lude]

dropped this in

[JPR28610]

fark man looking sexy

[patchwick]

today.. woke up...drove car to work and back...took a picture ..end!