EP3 Type R

[JDM EP3]

Check if you can adjust the headlight a bit further out?, or check if you have slotted back in probably, can't remember if the Ep3's have a metal lining to line up the front bar.

There are some round tabs that hold the bumper onto the car, wouldnt these allow it to line up properly if you allined it to the the holes?

[UNA91]

I thought it was the headlights at first but there wasn't much room adjustment on the headlights since they have these tabs/bumps that have to slot into these holes in the bracket. I did however, adjust the brackets that support the headlight, but since the bumper also sits on those brackets it would go out of place if i moved it, if that makes sense...

My guess is that i may have twisted my bumper slightly out of shape since i recall taking my bumper off and forgetting to take one plastic tab at the bottom corner on the drivers side, leaving my bumper half hanging while i remove the tab... =.=

[JDM EP3]

Oh does anyone also have any issues opening their fuel lid? I pop it and it wont open I had to wedge a credit card in there and pop the latch again until it opened, checked it out to see if it was a one off but it doesnt want to open with just the release. fuuuu!

[UNA91]

^that happened to me when i first got the car, what I found was the metal tab that clicks the fuel lid close was holding it too tight, so i just bent it a little and it's all goods.

[JDM EP3]

^that happened to me when i first got the car, what I found was the metal tab that clicks the fuel lid close was holding it too tight, so i just bent it a little and it's all goods.

Yeah I looked at the tab and thought of that but wasnt sure if I should bend it back.
Thanks

[Lukezen27]

Check if you can adjust the headlight a bit further out?, or check if you have slotted back in probably, can't remember if the Ep3's have a metal lining to line up the front bar.

yeah there metal line-up strips under the head lights but the rest are plastic strips with holes where the bumper has little knobs that need to go inside the plastic strips with holes

I've take mine off many times without any issues but the first time it didn't line up as good as i'd likeed to so I removed and replaced and BAM perfect

[wahyu4ever]

Hey mate,
Check out johno's thread. It's a great guide.

http://www.ozhonda.com/forum/showthr...ide-EP3-buyers!

Thanks Mate!

[twelve]

Anyone heading out to the jdm style tuning meet at wsid tomorrow night. Ill be out there and it would be cool to see a few other ep3's!

[Azz86]

Anyone heading out to the jdm style tuning meet at wsid tomorrow night. Ill be out there and it would be cool to see a few other ep3's!

Yep

[twelve]

Yep

Thoughts on it azz86? I was a little dissapointed with the crowd, a lot of f-wits. Saw probably 7 ep3's though!

[Poeter]

Thoughts on it azz86? I was a little dissapointed with the crowd, a lot of f-wits. Saw probably 7 ep3's though!

F-wits!? Thank goodness I didn't go.

[Azz86]

Thoughts on it azz86? I was a little dissapointed with the crowd, a lot of f-wits. Saw probably 7 ep3's though!

So many Ep3s getting around which was great to see. I didn't think there was that many around NSW.

It wasn't really about cars which pissed me off a bit. It was more about being a show off. Oh and the amount of terrible cars was disgraceful lol.