EP3 Type R

[Symphorced]

lucky I didnt really look into it more had the feeling it will be a problem thanks for the reply =)

No worries, Perry. I tried to fit a 17x9 +48 wheel with a 5mm slip on spacer and it still didn't sit properly and was still fouling on the coilover.

[Icebox]

Nah it's not there anymore =( was planning on getting that and sell off my current regas.

i was gonna buy it on the day went to pick up some piping for our 180 project car =[ but i didnt get paid on time so sad

My rear is 17x8 +45 it's pretty close the sussy already any higher will be GG

yeah i understand where your coming from, im running only 0.5 less in width

[butterfingers]

do you guys usually use 5th and 6th for streets and main streets with and avg speed limit of 60-70kph? or do you stay in 4th unless you get on freeways/go above 80kph?



and does exhaust drone/fuel consumption factor in your decision?

[UNA91]

do you guys usually use 5th and 6th for streets and main streets with and avg speed limit of 60-70kph? or do you stay in 4th unless you get on freeways/go above 80kph?



and does exhaust drone/fuel consumption factor in your decision?

I usually cruise in 6th when going 60km/h unless i know i need to speed up to 80km/h+ then I stay in 5th; I also take most turns in 3rd gear since my 2nd gear is pretty weak. I just keep my revs above 2k in general. Don't really have much droning whilst cruising, tho i do like to hear my exhaust sometimes.

[Perry]

60km I stay on 5th 70km + ill stay on 6th.

[Perry]

i was gonna buy it on the day went to pick up some piping for our 180 project car =[ but i didnt get paid on time so sad



yeah i understand where your coming from, im running only 0.5 less in width

Need to check out your car next time I see ya.

[Icebox]

do you guys usually use 5th and 6th for streets and main streets with and avg speed limit of 60-70kph? or do you stay in 4th unless you get on freeways/go above 80kph?



and does exhaust drone/fuel consumption factor in your decision?

60kms stay on 5th, 70+ 6th my exhaust drones a little but then again, my cars freaking loud~ lol

Need to check out your car next time I see ya.

sure, ive had a lot of stuff done to the car since the last time we meet at BYP HQ

[bennjamin]

no, it means the opposite.

lower the number, the more poke it has, relative to the wheel's width

Actually , it depends if it's PLUS or MINUS I front of the mm number measurement !

[butterfingers]

All good Then I was afraid I might have been lugging the motor gearing up too soon

[Lukezen27]

no, it means the opposite.

lower the number, the more poke it has, relative to the wheel's width

Ta

I always get em the wrong way round no matter how hard I try to remember lol

[Lukezen27]

Hows the sizing work with HUN CENTRIC RING?

Edit

Worked it out

[doosra]

Picked up some Weds Sport SA90's today for dirt cheap and have now got them on the ep3! 17 x 8, +35 offset. With my current height, there's some scrub on the rears when turning sharp or bumps in the road but not too bad with one person in the car