EP3 Type R

**UNA91** · 19-09-2013 10:24 PM

Originally Posted by stndrd

101 Motorsports in QLD? They know what they are doing as they helped build Mighty Mouse.

Dont get caught up on the numbers. Alot of variables involved when it comes to dyno figures (ramp rates, location of IAT, tyre profile, tyre pressure, how hard they strapped it down)

Yeah those guys, they have some impressive cars in the garage! Was just hoping to break into the 190-200hp mark.

This might be a noob question but looking at my dynosheet, what is that spike around the 4400 rpm mark? Is that where they just floored it for the dyno? Cause up until 5200rpm-ish it looks like its sorta hesitating to climb up? :S Looking at other poeples dyno, most of them just look pretty linear all the way to the top

And if the bottom dotted line is the torque curve, doesn't that seem abit low too? (not that we had much in the first place)

**stndrd** · 20-09-2013 01:06 AM

What mods are on the car?

**Vvvtec** · 20-09-2013 01:11 AM

hmmm yeah 125lb of torque does seem a little low

**UNA91** · 20-09-2013 08:01 AM

Mods are mugen intake, custom 70mm cat back and plm/kiddracing headers, maybe the torque explains why my car feels sorta flat when I do a 3rd gear pull.

The tune is also left in open loop, would that mean anything, since I thought after tune it's usually switched back to closed?

**viett** · 21-09-2013 05:50 AM

Hey guys, I was just wondering if PFL Civic Vi's (EU3) are interchangeable with PFL EP3R, just the bumper and side fender? And will a EP3R grill fit into a EU3 bumper?

**UNA91** · 21-09-2013 04:38 PM

Originally Posted by viett

Hey guys, I was just wondering if PFL Civic Vi's (EU3) are interchangeable with PFL EP3R, just the bumper and side fender? And will a EP3R grill fit into a EU3 bumper?

iirc the eu3 grill is moulded with the bumper. I've seen an ep3 with an eu3 bumper but I'm not sure of it's a straight swap.

**charliebrown** · 21-09-2013 05:29 PM

Originally Posted by UNA91

iirc the eu3 grill is moulded with the bumper. I've seen an ep3 with an eu3 bumper but I'm not sure of it's a straight swap.

This is a PFL EP3 with PFL EU3 bumper i think?

**UNA91** · 21-09-2013 07:26 PM

^yea lol thats the one i see driving around

**charliebrown** · 22-09-2013 01:40 AM

Opinion on Spoon progressive springs? Not that popular over here aye. Been searching everywhere for a set as they're discontinued, was able to find one, but its a bit pricey, close to $500 delivered

**Vvvtec** · 22-09-2013 12:21 PM

theyre brilliant

**latinstyle69** · 23-09-2013 12:50 PM

Originally Posted by charliebrown

Opinion on Spoon progressive springs? Not that popular over here aye. Been searching everywhere for a set as they're discontinued, was able to find one, but its a bit pricey, close to $500 delivered

I've been trying to look for them too!!