Your Mods To 2006-2011 FD Civics

[threesix]

perfect!

i had to get my guards hella rolled to fit 18x9 up back.

[dannyhuynh]

Replica mugen visors slowly stripping off haha mad flapping sounds when driving fast lolol

[jprak]

Replica mugen visors slowly stripping off haha mad flapping sounds when driving fast lolol

shouldnt happen unless you pushed it accidently like i did (my genuine ones) OR didnt clean the area properly =/

[Baygon]

Shieeeeeeeeeeeee
http://www.carpart4u.com/product/211...70RS-Dual.html

[stevo1210]

Would look funny on a stock height car though

Mud flaps look fine with stock Civic IMO. I had them on my car from new. Rear ones held on with screws and one clip... front held on with screws which penetrate the fender clips.
Will have to let mine go in the future so the Modulo side skirts can be installed.

[jprak]

Shieeeeeeeeeeeee
http://www.carpart4u.com/product/211...70RS-Dual.html

makes my FD2R 60RS a toy =='

[lolmclol]

Shieeeeeeeeeeeee
http://www.carpart4u.com/product/211...70RS-Dual.html

Ballin'

[Honda_FD]

So as you may know. My car was rear ended recently.
And because of that my xForce Twin Loop Muffler was damaged in the accident.
Since its not an illegal modification they're paying me out for a brand new one ($300)
But since they're going to deposit the money into my bank I'm thinking of putting in a
little extra for a Varex Muffler (VMK8-250) They go for $450 fitted

That way i can fart around town and then close it up when im near home.
My twin loop in fine though. It just has a cracked tip.

Thoughts?

[NeedVtec]

Shit get the varex mate. Just a better investment and probably would save some head aches, literally.


Where you get the quote for 450 install?

[Honda_FD]

Shit get the varex mate. Just a better investment and probably would save some head aches, literally.


Where you get the quote for 450 install?

TrueFlow in Westwood Drive. Near DeerPark.
They distribute for xForce, Redback, Iron Man and all that.

Which part of Melbourne are you from?

http://www.trueflowexhausts.com.au/c...t-safety-check

[NeedVtec]

West burbs, 10min from there. Was keen on getting exhaust, especially for 450 indtalled. Is it straight bolt on? Need to know if I can put my stock one back on

[Honda_FD]

West burbs, 10min from there. Was keen on getting exhaust, especially for 450 indtalled. Is it straight bolt on? Need to know if I can put my stock one back on

The Varex has a flange at the back. So I think they might have to cut the pipe that connects
to the stock muffler and weld a flange onto that. Well, Thats what they did to my Twin loop.