all you need is diy a ground kit.
its been discussed before.
if you run a high current draining large stereo then all that is really needed is a larger battery ground to the chassis cable. leave the stock one but just add a tank one.
if this is not enough you can daisy chain to another pt.
this is what i do. ive got 4 grounding pts connected to a bus bar with 4GA cable.
and the very short gnd cable that goes straight to the chassis which is also daisy chain to a another point 10-15cm away.
at the rear the amp(s) grounding is daisy chained to 2 additional locations. ie 3 pts. this kind of thing may be needed when you ask an amp to suck up to 200a of current.
those pivot and raisin voltage stabiliser are TOTAL WASTE OF MONEY
some people may just think its bling with the blue led.
Reply With Quote
Bookmarks