Page 2 of 5 FirstFirst 12345 LastLast
Results 13 to 24 of 49
  1. #13
    Member Array
    Join Date
    Dec 2006
    Location
    Gold Coast/NSW
    Car:
    06EuroLux6M
    Most squeaks have a source and a remedy, but none here yet.
    My preference was to having the damping adjustment to fine tune to local roads for ride comfort.
    133.4kw atw
    14.8 - 400m Willowbank

  2. #14
    Member Array
    Join Date
    Aug 2006
    Location
    Sydney
    Car:
    06 Euro luxury manual
    Quote Originally Posted by Merlin086 View Post
    Most squeaks have a source and a remedy, but none here yet.
    My preference was to having the damping adjustment to fine tune to local roads for ride comfort.
    Like i said i've only heard this so hopefully you won't have any problems.

  3. #15
    Member Array
    Join Date
    Jul 2006
    Location
    Sth Eastern Suburbs Melb.
    Car:
    06 Accord Euro lxry

    patiance...My advice to you

    Quote Originally Posted by gromit View Post
    Hi all
    My 07 LE euro is now just 11 days old
    Absolutely loving the car and still stealing glances everytime i walk away from it.
    Now I'm looking for advice on lowering the car. Any ideas what brand, ride height, price or where i can get it done in Perth (Only been here for 1 month now!). Don't want it stupid low though scraping off roadkill.

    Any suggestions appreciated!
    Hi I have recently lowered mine too (eibachs) need the shocks though...anyway I have had problems with drifting and camber bias to the right happened 5,000-6,000klm mark, still have the problem with camber bias (pulling to the right under camber more than normal), They (Honda Aust.) knocked back the offer of new tyres because of mod to suspension and now telling me that suspension warranty void....just letting you know what you may be in for if you do have drifting problem later....I am about to put my old springs back in my car to fight Honda Aust. over this issue....Patiance I say up until your 10,000 klm mark.

    Hope this helps you

    Read this thread before you decide

    http://www.ozhonda.com/forum/showthread.php?t=22067




    Congratulations on your purchase

  4. #16
    Member Array
    Join Date
    Aug 2006
    Location
    Sydney
    Car:
    06 Euro luxury manual
    I swapped my stock suspension for the Eiback/Bilstein setup 2 weeks from new and i've had NO problems at all.It is now 10 mths.16000klm.later.I also changed my tyres to Conti sport Contact 2s.I believe that the majority of these drifting/pulling issues are to do with the suitability/compatibility of these tyres(Bridgestone RE-O40)IMO the OEM tyres are CRAP.I suggest you change the OEM tyres while they are virtually new because you'll still get a good trade in on them.

  5. #17
    Member Array
    Join Date
    Nov 2006
    Location
    Melbourne
    Car:
    2003 euro 6 speed
    tein ss all the way

  6. #18
    Member Array
    Join Date
    Dec 2006
    Location
    Gold Coast/NSW
    Car:
    06EuroLux6M
    My euro lux was new end November.
    Never had drifting tendancies, only noticed slight tramlining on deep grooves. Switched to chrome stock size rims at 1k, after a wheel alignment check at the 1k service. All OK. Still running stock Bridgestone 225/45 17's

    Lowered 2" on Tein SS a month later and haven't noticed any tramlining since.
    So I haven't noticed any drift with stock tyres at all, the only difference is my offset is 45mm, so maybe increasing the track 20mm has helped.........who knows?
    133.4kw atw
    14.8 - 400m Willowbank

  7. #19
    Newcomer Array
    Join Date
    Apr 2007
    Location
    Perth
    Car:
    07 Euro LE
    All helpful comments thanks guys.

    Out of interest is the CL7 suspension setup much lower and is it advisable to slap them on the CL9?

  8. #20
    Ninja turtle Array
    Join Date
    May 2004
    Location
    Sydney
    Car:
    Chloe
    Quote Originally Posted by LXRY View Post
    Hi I have recently lowered mine too (eibachs) need the shocks though...anyway I have had problems with drifting and camber bias to the right happened 5,000-6,000klm mark, still have the problem with camber bias (pulling to the right under camber more than normal), They (Honda Aust.) knocked back the offer of new tyres because of mod to suspension and now telling me that suspension warranty void....just letting you know what you may be in for if you do have drifting problem later....I am about to put my old springs back in my car to fight Honda Aust. over this issue....Patiance I say up until your 10,000 klm mark.

    Hope this helps you

    Read this thread before you decide

    http://www.ozhonda.com/forum/showthread.php?t=22067




    Congratulations on your purchase
    If you lowered your car without installing a rear camber kit to get the camber back to spec, your car WILL pull to the right. Mine did after lowering by 25mm. My rear camber went to -3 and I had severe pulling to the right. I could take the right curve in the M5 tunnel without my hands on the wheel and steering set to being centered. In order to drive straight, I had to keep my hands on the wheel and had the steering wheel pointed slightly to the left. As a bandaid fix, I put 0.3mm more toe in on the right to reduce the pulling. I've got my camber kit and will set both my camber and toe back to factory specs and will report whether my pulling goes away after restoring the rear camber from -3 back to -0.5.
    --------------------------------------
    Stocky CL9 - 1:17.2

  9. #21
    Polar Bear Array
    Join Date
    Sep 2005
    Location
    Melbourne
    Car:
    09 RB1 Lux
    If you wanna spend more i can get you bolt-on air suspension for euro
    Team Agentz

    Options Motorsports

    My Accord Euro: [ENDUT]

    My Odyssey: [BRUANG]

    MY GARAGE SALE

  10. #22
    Newcomer Array
    Join Date
    Apr 2007
    Location
    Sunshine Coast
    Car:
    Accord Euro Luxury 03
    Quote Originally Posted by tony1234 View Post
    I've got Eibach springs with Bilstein shocks,drop is approx.35mm(just right!).i'm in Sydney so can't help with where to get it done.IMO Eibach springs really suit the Euro as it's a sport/luxury car.As for shocks i'd go for either Bilstein or Koni both cost about the same and again suit the type of car the Euro is.BTW welcome.
    Just wondering how much Eibach springs with Bilstein shocks would cost...?

    if i lowered my euro 35mm i would need a camber kit too right...?
    how much and what brand...?

    cheers
    "Success is 99 percent failure" Soichiro Honda

  11. #23
    For me its either the best set up or nothing.. and what i wanted was to lower my car without worrying about.. "ohhh its not low enough" or "damn it its too low" so i decided to go for a fully adjustable suspension with full ride height and damper adjustable. this way i wouldnt also have to worry about the car being too stiff or too soft. At first i wanted to get the Eibach and Bilstein set up, but then i also thought about getting a bodykit and 19 inch rims. there isnt much that i can do with the Eibach/Bilstein set up. so i had to choose carefully and decided to go with TEIN Flex. Cost alot more.. but its worth it. ive dumped my car by 2inch front and rear, appearance wise.. makes tha car look more sexy, the body sits right on top of the tyres. the handling? *2 thumbs up*

  12. #24
    Ninja turtle Array
    Join Date
    May 2004
    Location
    Sydney
    Car:
    Chloe
    2" drop on flex with a bodykit. Wouldn't you be scraping the bottom of your car on the thin metal speed bumps in the shopping mall?
    --------------------------------------
    Stocky CL9 - 1:17.2

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBadvanced CMPS v4.1.3


Terms and Conditions
Ozhonda.com is in no way affiliated with the Honda motor company or Honda Australia in anyway whatsoever.