would be better off doing a custom headers instead??
Or the OEM header is good enuff?
Depends on your budget and what mods your after. OEM header is not bad, but can be improved. In no way am I comparing it to a Toda header etc....but then again modding the OEM header wont cost a few weeks wage either!
The OEM header is a properly made stainless steel header with mandrel bends, so i'd say it aint too bad!
Steve, I'll put something up as soon as I get my roster tomorrow. Cant organise something when I dont know when I am available
hmm do like aftermarket header's have build in cat's?? just like the OEM's??
In short....NO!
Heres an idea of cost! Its a rough guestimate but I'd be quite close!
Mugen header with cat $2500ish
Toda race header (no cat) $1500ish
Buddy club race header (no cat) $1300ish
Maximworks header with cat $2500ish
SSR raceheader (no cat) $2500
Basically you'd be spending $1500 upwards to have a set of headers modified with a cat!
Working with my $100 per KW principal......fail unfortunately, money better spent elsewhere!
thinking of selling my ep3. What do you think i should advertise for?
2002 Model - 25000 kms
Mugen Double Loop Exhaust
Mugen Airbox
Carbon Front Sway Bar
Rear Sway Bar
Endless Brake Pads
Razo Gear Knob
JVC Deck
Top of the range Pioneer Speakers throughout
Carbon Tweeter Mounts
Recent Service
Rays Gram Lights - 57 Maximum - 17 inch unmarked perfect condition
HKS FCON IS
Bookmarks