Calibrating the Voltage on the TPS

[beeza]

Sounds the throttle plate is a bit open.

First try the idle screw,U may be able to screw it in and control that idle that way.

OR

The TS screw is holding the throttle plate open,in which case,just wind it out until it settles.The CT voltage will be lower but dosen't matter as long as it's idling fine and going fine.This happened on Timmy's car and the CT voltage was 0.43 and WOT 4.5 but it did not affect the performance.

Stay positive mate! All this will learn ya good!