how to check transmission fluid in eg

[grifty]

if u want to check the fluid remove the large round bolt (can be seen in the pic 2 posts above) above the drain bolt with a 3/8 ratchet or breaker bar

[Lukey]

remove the filler plug and put ur finger in there to check the level

[One Fighter]

No offence but at least read the replies (ie the first reply) where people are actually helping you out.

-_- its ok, but i did read it, as i said before kinda new to the manual trans, since i owned before a auto.

thanks anyways.

[One Fighter]

if u want to check the fluid remove the large round bolt (can be seen in the pic 2 posts above) above the drain bolt with a 3/8 ratchet or breaker bar

thanks for the help, thats all i wanted to know, so theres 2 bolts, one to drain and one to check.

thanks.

[89lude]

your inbox is full one fighter...im pming you about the motor.

[One Fighter]

your inbox is full one fighter...im pming you about the motor.

yea sorry i just cleaned it up now. :P

[yuffie_5201314]

which square socket fits in the drain plug??

[1590cc]

3/8 drive sockets mate.

[yuffie_5201314]

ta, i got everything ready but when i tried to loosen the filler bolt it was way too tight is there another way 2 loosen it besides a 17mm spanner

[Lukey]

ta, i got everything ready but when i tried to loosen the filler bolt it was way too tight is there another way 2 loosen it besides a 17mm spanner

socket, breaker bar, and a pipe on top of the breaker bar for more leverage, make sure the socket in on firm as the last thing you want to do is strip it.

[OMG.JAI xD]

Try a longer spanner.
Or connect 2 spanners together. 17mm with a 18-19mm on the open ended side to give more leverage. Theyd always be tight. Other wise it'd leak =/