Quote Originally Posted by marquee View Post
I'm not sure if your serious.

This may seem like a stupid idea but if you try and tighten it and then loosen i have found sometimes that works.

If that fails i would wd40 and breaker bar hope for the best.

Then grab the breaker bar and hit the guy who tightened them up natsrs
I would say horrible move.
Mostly because the wheel is not on the ground, so it'll spin freely... unless it's in gear, which I imagine isn't very good for the gearbox... I don't know if it's bad for it, I just like to think it's bad for it. Handbrake, eh. (towards the quote you quoted I mean... just realised that as I went to post this... derp)

So yeah, as I said earlier, get a 1/2" breaker bar, get the socket size you need, put it on there, get a huge goddamn piece of pole, wd40 if you must, and pull or push on the bloody pipe. It SHOULD undo it. If not, things have gone sideways, and I'm stumped.