The sound is coming back again, there is some sort of interference with the left speaker
Not sure what the cause is but I do have a few theories:
1. The four wires need to be solder onto the speaker. Because the factory harness did connect two onto one speaker terminal of either (+) or (-)
2. The speaker terminal may be touching the metal door but I don't think so.
Is there a way to check if the left speaker is generating unwanted signals? Testing the wire with a MM or something? If so, how would I do this?
The sound is very low frequency and it's hard to notice but after a drive- my left ear is jammed while right is fine.
It was much better than before but the sound generated from the speaker comes and goes? remount always does the trick (did it twice).
I only realised today that the sound was coming because left ear is jammed while right is ok, so then I touched the left speaker and noticed it was vibrating which means the sounds are being created but hardly noticeable and it definitely does do some damage to the ear.
Edit: Tried to explain it better
Reply With Quote
Bookmarks