Quote Originally Posted by Val View Post
Been away and very busy lately. Did a little bit of work today, trying to clean out the engine bay as much by removing anything i can. Im thinking i will sand it down and spray it before i start on anything else. I ran into a problem though, i've undone 1 bolt from the hardlines for the brakes, however every single other bolt is rusted to the connections i tried un-doing them, but the spanner just take off an edge of the bolt and comes off. Now i need some ideas on what i can do about it.

I though use a dremmel to cut off at the hardline ends, then used a flaring tool and replace the screw in bolts, considering i plan on using the DA9 BC and booster.

Anyone got a flaring tool i could borrow just for a few hours?
were you using an open ended spanner? if so that tends to happen (corner rounding off). Invest in some flare nut spanners and that will stop happening. Ummmm once they are rounded off the best bet that I know of to remove them from the brake component is with vice grips. Its gonna screw the flare nut but as you've said they are already screwed.

Flare nut spanner ref image: